User`s manual
HokutoElectronic FLASH1 User’s Manual
-9-
Basic Operation
① Prepare target board Please refer to preparation 1
② Install the control software Please refer to preparation 2
Connecting PC and target board
Please refer to the diagram below
③ Execute the software
④ Supply the power to objects
⑤ Setting (MCU ・communication rate)
⑥ Select file
⑦ Complete programming
Finish
Start FLASH1forWindows
FLASH1forWindows can execute with select “Hokuto Denshi” group in “Program” from pull-up menu of “Start” , if
you had nothing to change in installation.
Check “Help” of FLASH1forWindows
Caution!! Sample programs are not automatically copy at the installation of the control software.
We recommend copying at first, if you need confirm the connections.
①Select COM Port
②Select
parameters ;
Initial Bit Rate
and Maximum
Bit Rate and
MCU t
yp
e.
③Select File
④Start Writing
/Stop Writing (while writing)
Optional Verify
A
t the end of writing,
progress continues to
verify by check sum.
Log Information
is appeared
here about
recent writing.
Help in FLASH1 for Windows -contents-
●At Beginning●Feature●Specifications●Connections and Advices●Preparation of Target Board
●Basic Operation●Writing Flow of FLASH1●Timing Chart in Start of Boot Mode●Error Messages
Lack of Vpp Voltage/Bit Rate Adjustment Error/ Invalid Code Accepted/
Erase Error/Flash Memory Erase Error/Invalid File Format/Data Transmission Error
⑤Exit
Close FLASH1forWindows
⑤ Help Operations
and Trouble Shootings
Language
Select from Japanese and
English.
HSB board can be used as it is.
Power
ON
Target board
Flash memory MCU
Power In
A
C adapter or Dry batteries
RS232C
Straight
cable
P
C
FLASH1forWin
FLASH1
Target cable