Technical information

ii
Contents
Section 1 Overview........................................................................................... 1
1.1 Environment Conditions
....................................................................................................1
1.2 Supported MCUs and User System Interface Cables
........................................................2
1.3 Operating Voltage and Frequency Specifications
..............................................................4
Section 2 User System Interface........................................................................ 6
2.1 Signal Protection
...............................................................................................................6
2.2 User System Interface Circuits
..........................................................................................6
Section 3 Notes on Use ..................................................................................... 10
3.1 I/O Register Differences between Actual MCU and E6000
..............................................10
3.2. Access to On-Chip RAM Area
..........................................................................................10
3.3 Support of Flash Memory
..................................................................................................10
3.4 Optional SIMM Memory Module
.....................................................................................11
3.5 Emulating the H8/3048-ONE
............................................................................................12
Section 4 HDI Parameters................................................................................. 13
4.1 Address Areas
...................................................................................................................13
4.2 Access Status
.....................................................................................................................14
Section 5 Diagnostic Test Procedure ................................................................ 15
5.1 System Set-Up for Test Program Execution
......................................................................15
5.2 Diagnostic Test Procedure Using the Test Program..........................................................16