Instruction manual

Site Schematic Check List
60 Access Control Design Guide
 The backup power source for each cabinet (normally a 12V 7AH battery)
 Where to ground each cabinet
 Cable supervision level for monitor points
 Details of any additional power supplies required for auxiliary outputs
Elevator Nodes (if used)
For each elevator node, mark the following:
 The locations of the master and slave units.
 Cable requirements and routes
 Any conditions required by the Federal Fire Code or other local regulations
 Whether Enable All or Enable Select Mode is to be used
 Whether the Free/Secure relay is required
 Whether Tenant Security is required
 Whether a Fireman's Switch is required
 The address of the database unit (one to 32)
If the node is the first in a chain:
 The communications method to an SMS PC
 The location of the network socket, telephone socket (for modem communications) or PC (for
serial communications), as appropriate
 The IP address of each NIC-4 and NIC-WI (if applicable)
 The port usage bit-switch settings
 The power source
 The backup power source (normally a 12V 7AH battery)
 Where to ground the cabinet
 Details of any additional power supplies required for external devices
Antipassback (if used)
If antipassback is used, mark the following:
 Whether Timed or Zonal antipassback is to be used
 Which database units belong to the same antipassback scheme (for zonal antipassback)
 The to and from zone (one to 63) for each antipassback reader (for zonal antipassback)
 The timeout period for each antipassback reader (for timed antipassback)
Readers
For each reader, mark the following:
 Reader type
 Mounting location and height