User`s manual

Applilet EZ for HCD Controller CHAPTER 5 WINDOW REFERENCE
R20UT0435EJ1200 Rev. 12.00 35
Jul 31, 2014
Remark When the EV-K0-HCD, EV-K0-HCD2, and EZ-0009 are selected and the CPU clock is set to the internal
high-speed oscillation clock (f
RH), the data received first is used as data for calibration (refer to Remark in
4.3.4 Serial Command mode). The settings made via the [UART6 Settings] or [UART0 Settings] dialog
box result in the communication data format after calibration.
[IIC Property] dialog box
This dialog box can be opened by clicking [I
IC...] in the [Project] menu.
Set IIC in this dialog box.
This setting operates only in slave mode.
Figure 5-3. [IIC Property] dialog box
The following parts of this window are described below.
 Description of function-related areas
 Function buttons
Description of function-related areas
(1) O
peration Mode:
This is fixed to Standard (100 kb/s) and cannot be changed.
(2) Slave A
ddress:
A numeral of 8 to 119 can be entered. 24 is entered by default.
Function buttons
Button Description
Click this button to save the current settings and close the open dialog box.
Click this button to close the open dialog box without saving the current settings.
Note A half of the value set in the field becomes IIC bus slave address.
For example, when 9 is set in the field, the address becomes 7-bit slave address as "0001001."
(1)
(2)