User`s manual

Applilet EZ for HCD Controller CHAPTER
4 APPLILET EZ FOR HCD CONTROLLER OPERATION
R20UT0435EJ1200 Rev. 12.00 28
Jul 31, 2014
<4> Operating preparation
• If the board has a USB interface
When the program has been written normally, toggle the Program (PROG)/Run (RUN) switch to “RUN” and then
turn the evaluation board off and on.
• If the board is using MINICUBE2
Switch OFF the power of the board, remove the connection of MINICUBE2, and turn ON the power of the
evaluation board once again.
<5> Operating
• For EZ-0011 or RL78/I1A AC/DC Full digital 3ch LED control unit
Perform the auto tuning operation (lights all the LEDs of the connected channels) first to check the characteristics
of the connected LEDs. To start the auto tuning, push the switch 1 (SW1) after power ON. The operation of auto
selected program starts after the auto tuning.
If an illegal condition (such as internal overvoltage) occurs, the LEDs are automatically turned off and the operation
backs before auto tuning. In that case, push the switch 1 (SW1) again to start again from the auto tuning.
Note
• For boards other than the above
The operation will start immediately when the power is turned ON.
Note When protection against the circuit by the comparator is actuated in the RL78/I1A full digital LED control unit,
the status lamp will be turned on and off. In such cases, push a reset switch to start an auto tuning again.
Caution Since the Write/Execute procedure differs depending on the board used, see the board’s manual for
details.
Remark When only generating object codes (*.hex), click
icon.