User`s manual

Applilet EZ for HCD Controller CHAPTER
4 APPLILET EZ FOR HCD CONTROLLER OPERATION
R20UT0435EJ1200 Rev. 12.00 25
Jul 31, 2014
4.4 Generation, Writing, and Evaluation
In the following procedures, object codes (*.hex) are automatically generated and software is written to a microcontroller.
After writing has been completed, the operation can be checked by using the evaluation board.
The write procedure differs depending on the board used.
If the board has a USB interface, first confirm that the PC and USB cable are connected properly.
<1> Click the
icon to open the Build window. Preparation for generating object codes (*.hex) and writing will be
performed.