User`s manual

Applilet EZ for HCD Controller CHAPTER
4 APPLILET EZ FOR HCD CONTROLLER OPERATION
R20UT0435EJ1200 Rev. 12.00 18
Jul 31, 2014
<1> Select the [Analog Input] button in Dimmer Program and specify from the [use] drop-down list the A/D conversion
value to be used for the duty.
(For the EV-K0-HCD)
 [each channel]
The conversion value of each A/D conversion port is applied to the duty of the corresponding effective channel.
<Example> When Channels 1 and 2 are effective
ANI0  Channel 1
ANI1  Channel 2
 [ANIx only]
The conversion value of the selected A/D conversion port is applied to the duty of all effective channels.
<Example> When ANI3 is selected and Channels 1 and 2 are effective
ANI3  Channels 1, 2
Caution ANIx varies depending on the evaluation board.
<2> Set the number of samples to be used in moving average processing.
Caution When the number of samples is set to 1, the moving average processing is not performed.
<3> Click
icon or select Menu  [File]  [Save] to save the project.
Remarks 1. To use this mode, an analog signal source must be connected to the analog input port (ANI) of the
microcontroller. For details, refer to the user’s manuals of the microcontroller and evaluation board.
2. The moving average interval is 5 ms.