User`s manual

Applilet EZ for HCD Controller CHAPTER
4 APPLILET EZ FOR HCD CONTROLLER OPERATION
R20UT0435EJ1200 Rev. 12.00 16
Jul 31, 2014
(a) Selecting the channel to operate
Select the channel to edit. Only channels that can be edited can be selected.
Select all channels or individual channels.
The brightness curve of a selected channel is displayed as a bold line.
(b) Selecting the operation mode
Range selection
mode
A range can be selected by left-clicking and then dragging the mouse in the brightness
curve editing field. Editing tools are used for the selected range.
Freehand line
mode
A freehand line can be drawn by left-clicking and then dragging the mouse in the
brightness curve editing field. This mode is enabled only if one operation channel is
selected.
Clear mode
All data of the selected channel is cleared.
CSV editing
mode
The brightness values are output to a CSV file and an editing application (the
application associated with the extension .csv) starts. Control does not return to
Applilet EZ for HCD Controller until the application is closed.
(c) Editing tools
Straight line
Turns changes in the values of a selected channel or selected range into a straight
line.
The straight line connects the values of the start and end positions in the selected
range.
Maximization
Sets the values in the selected range to their maximum specifiable values.
Minimization
Sets the values in the selected range to their minimum value (0).
Color
specification
Specifies the color of a value in the selected range from the color specification
window. This tool is enabled only if all operation channels and a range are
selected.
Shifting
Shifts the values in the selected range to the left, right, up, or down by one point. If
these buttons are clicked while holding down the [Ctrl] key, the values shift in 10-
point units.
Cutting
Cuts the values in the selected range and temporarily retains them in a buffer. The
cut values can be pasted to any position by using the paste button. This tool is
enabled only if one operation channel is selected.
Copying
Temporarily copies the values in the selected range to a buffer. The copied values
can be pasted to any position by using the paste button. This tool is enabled only if
one operation channel is selected.
Pasting
Pastes the data temporarily retained in a buffer. The position to which to paste the
data must be selected as a range. Multiple channels can be selected for pasting.
Values that were cut or copied when one channel was selected are applied to the
values of the selected channels.
Undo
Undoes the previous operation. This can be used to undo only the most recent
operation.