User`s manual

Applilet EZ for HCD Controller CHAPTER
4 APPLILET EZ FOR HCD CONTROLLER OPERATION
R20UT0435EJ1200 Rev. 12.00 13
Jul 31, 2014
4.2 Setting Up the Evaluation Board
In the menu, select [Project] and then [CPU] to set up the evaluation board in the dialog box below.
Performing this setup updates the specified mode displayed in the main window.
(1) Target:
Select the evaluation board to use.
(2) D
evice:
If an evaluation board is selected, the mounted microcontroller is displayed. (This setting cannot be changed.)
(3) C
lock Source:
Select the clock to use. This setting might be fixed depending on the setting of (1).
(4) F
requency (MHz):
Select the frequency. This setting might be fixed depending on the setting of (1) and (3).
(5) Channel X:
Specify the channels to enable by selecting their [Enable] checkboxes.
Specify the color of the lighting of each channel by using the [Color] buttons.
These settings might not be selectable or changeable depending on the setting of (1).
Enter the max current level of each channel in [Limit].
* This setting may be unavailable, depending on the board.
(6) E
nable ‘On Chip Debug’.:
If this checkbox is selected, a program that enables on-chip debugging is generated.
If this setting is specified for the EV-K0-HCD, EV-K0-HCD2, and EZ-0009, UART6 cannot be selected in serial
command mode.
(1)
(2)
(3)
(4)
(5)
(7)
(8)
(6)