User`s manual

Applilet EZ for HCD Controller CHAPTER
4 APPLILET EZ FOR HCD CONTROLLER OPERATION
R20UT0435EJ1200 Rev. 12.00 12
Jul 31, 2014
Setting up the evaluation board (from the previous page)
Mode setting
Refer to 4.3.1
In this mode, the LEDs are dimmed according to the
input fixed values.
Fix mode
Refer to 4.3.2
Variable mode
Switch mode
Refer to 4.3.3
In this mode, the LEDs are dimmed according to the
A/D converted values.
Analog Input mode
In this mode, LED dimming can be continuously
changed. The output pattern can be specified as in
art software.
Refer to 4.3.4
Refer to 4.3
In this mode, the LEDs are dimmed by using
commands depending on the type of communication.
Specify the communication format, communication
command type, and channels to use for serial
communication.
Serial Command mode
Save the project
Generation, writing, and evaluation (refer to 4.4)
Refer to 4.3.5, Chapter 5
In this mode, the LEDs are dimmed using the
DMX512 protocol.
Select
DMX512 mode
Menu -> [Project] -> [DMX512]
Refer to 4.3.6, Chapter 5
In this mode, the LEDs are dimmed using the DALI
protocol.
Select
DALI mode
Menu -> [Project] -> [DALI]
In this mode, the dimming levels are changed by the
switch connected to the board.
Caution Some modes may be unavailable,
depending on the board
specifications. For details, see
the each board
,
s manual.
Refer to 4.3.7
Select Click the [Edit] button
Refer to 4.3.8
In this mode, the LEDs are dimmed using the remote
control signal reception function on the board.
IR remote control mode
Refer to 4.3.9 for Motion Sensor mode
Refer to 4.3.10 for Light Sensor mode
In these modes, the LEDs are dimmed by using
the motion sensor and light sensor connected to
the board, respectively.
Motion Sensor/Light Sensor mode