User`s manual

Applilet EZ for HCD Controller CHAPTER 3 STARTING AND ENDING
R20UT0435EJ1200 Rev. 12.00 10
Jul 31, 2014
(b) Specifying the folder in which to save the generated configuration file (*.xml) and the source and project files
(*.prj).
On the [Setting] menu, select [Project Folder] . The following dialog box will then be displayed.
Change the location where the *.xml and *.prj files are saved as required.
(c) Flash programming setting
The COM Port connected to the flash memory programmer or the board is specified here.
The location for setting will vary depending on the board used.
On the [Setting] menu, select [Flash Program…] .The following dialog box will be displayed when menu.
If the evaluation board (EZ-0011, etc.) is using MINICUBE2, specify the place where the programming GUI QB-
Programmer is installed in “for EZ-0011”.
If an evaluation board which has a USB interface (EV-K0-HCD, EV-K0-HCD2, or EZ-00xx) is used, select the
connected COM Port in “Other Board” and press the [OK] button.
Remark If an evaluation board which has a USB interface is used, leave the setting of step (b) as AUTO, because
the COM port will be automatically detected. However, if multiple boards are connected or boards cannot
be properly connected, select the COM port to which the boards are connected.
3.2 Ending
To exit from Applilet EZ for HCD Controller, go to the Main window’s [File] menu and select [Exit].
Folder in which to save the generated
configuration file (*.xml) .
Folder in which to save the source and project
files (*.prj) .