User`s manual
Applilet EZ for HCD Controller CHAPTER 1 OVERVIEW
R20UT0435EJ1200 Rev. 12.00 3
Jul 31, 2014
EZ-0005··················· This is an evaluation board for high-brightness LEDs that uses the
PD78F0756 (78K0/IB2).
Red, green, and blue LEDs are mounted on the board. The LEDs can be controlled by
using the internal features of the
PD78F0756 and an FET without the constant-current
driver IC.
EZ-0006··················· This is an evaluation board for high-brightness LEDs that uses the
PD78F0754 (78K0/IA2).
Red, green, blue, and white LEDs can be controlled in up to 16-bit resolution, by using this
board with the EZ-0007 (a
PD168804 voltage reduction HBLED evaluation board).
EZ-0009··················· This is a development kit for the
PD78F8024 and 78F8025.
This kit consists of a simple on-chip debug emulator and a target board. Up to four LEDs
can be controlled by adding circuits to the
PD78F8025 mounted on the target board.
EZ-0011··················· This is an AC/DC evaluation board that uses the
PD78F0756. It can control PFC and up to
3ch of LED. It writes in the microcontroller. MINICUBE2 is used to debug.
EZ-0012··················· This is an evaluation board for LEDs that uses the RL78K/I1A.
Red, green, and blue LEDs are mounted on the board. The LEDs can be controlled by
using the internal features of the L78/I1A and an FET without the constant-current driver IC.
RL78/I1A AC/DC······ This is an evaluation unit for the LED power source with the RL78/I1A implemented. It can
control the power factor correction circuit (PFC) and up to three channels of LED. Writing to
the microcomputer and debugging are handled by using the on-board USB interface or E1.
Notes 1. The supported development environment differs depending on the OS used.
2. When using a software tool made by Renesas Electronics, software can be automatically generated using
Applilet EZ for HCD Controller without installing a device file.
However, to develop a system in the integrated development environment PM+ by using the generated
source file, a device file must be installed.
Device file for
PD78F8024, 78F8025: DF788025
Device file for
PD78F0754, 78F0756: DF780756
3. This includes the integrated development environment PM+.
4. The device file for PM+ is necessary to re-edit or re-compile a source file that was generated by Applilet EZ
for HCD Controller in PM+. The device file is not required when using the source file only in Applilet EZ for
HCD Controller.
5. “xxxx” indicates the version.
6. Applilet EZ for HCD may not operate depending on the versions of the complier, assembler, and device file.
7. Use e2studio from Renesas as the integrated development environment for GNURL78.
Cautions 1. It is recommended that the latest service pack be installed for any OS.
2. Applilet EZ for HCD Controller requires the compiler, assembler, or integrated development
environment and device file of an Renesas Electronics or IAR Systems product.
Remarks 1. For details about how to obtain compilers, assemblers, integrated development environments, and
device files, contact your local Renesas Electronics sales representative.
2. For details of the evaluation boards, refer to each user’s manual.
(78K0/Ix2LED)
full digital 3-ch
LED control unit