User`s manual

Warnings Display on Product
Do not use this board in the purpose except the evaluation of MCU.
This board is developed for Power electronics engineer and it use is only for MCU evaluation. This board
does not take safety measures or anti-EMI measures required for lighting equipment and power supply unit.
Do not use this board in other countries outside Japan.
This board is assumed to be used only in Japan and it may not comply with regulation or standards of any
other countries except for Japan.
Do not touch to the high voltage area of the board.
Touching the board by tools or body while power is being supplied cause product failure or electric shock.
Do not touch with wet hands.
Doing so cause product failure or electrical shock.
Do not use or store this board in any of the following locations.
- Environments with copious water, humidity, steam, dust, fumes, etc.
- Environments where static electricity or electrical noise is readily generated.
Such influences can lead to electric shock or product failure.
Limit the user of this board.
Use glove to protect electric shock.
Be careful to burns.
The part of board becomes high temperature during AC power is connected.
Do not disassemble or modify the board.
Doing so may cause product failure, emission of smoke, fire or electric shock.
Do not heat the board or expose it to fire and do not short the terminals.
Doing so may cause product failure, generation of heat, fire or rupture.
Do not drop or jolt the board.
Doing so may break or damage the board, causing fire or electric shock.
Use AC power supply in the range of 100 VAC to 240 VAC.
Using AC power supply out of this range may cause product failure, generation of heat, fire or electric shock.
Do not plug in or unplug a connector or cable with power applied to the board.
Doing so may cause product failure, generation of heat, fire or rupture.
Do not turn on the power switch in insufficient state of each cable connection such as AC power
cable, LED connection cable and interface cable.
Doing so may cause product failure, generation of heat, fire or electric shock.
Do not carry this board with connecting any cable.
Doing so may cause damage of cable and cause product failure, generation of heat, fire or electric shock.
Do not use except the AC power cable attached to this board.
Using a incompatible cable may cause product failure, generation of heat, fire or electric shock.
Do not put or leave any electrical conductor, if you open the chassis.
A conductor on the circuit of the board may cause product failure, generation of heat, fire or electric shock.
Confirm the outlet is near this board and easily unplugged.
If smoke or an abnormal smell or sound is emitted or heating occurs, promptly switch off the board
power and unplug from AC power supply.
Using the board in such a state poses a risk of fire, burning or electric shock.
Warning
Danger