User`s manual

EZ-0011 CHAPTER 3 USING EZ-0011
R20UT0702EJ0100 Rev. 1.00 Page 15 of 30
Jun 20, 2011
CHAPTER 3 USING EZ-0011
3.1 Preparation
3.1.1 Downloading software
To perform development and evaluation of software using this product, the following software is required.
•Assembler for 78K0 core (RA78K0)
•Compiler for 78K0 core (CC78K0)
•Device file (DF780756)
•Parameter (PRM78F0756)
•Integrated debugger (ID78K0-QB)
•Programming GUI for MINICUBE2 (QB-Programmer)
•Software auto generation tool (Applilet EZ for HCD)
To perform evaluation of DALI communication/DMX512 communication using the lighting communication master
evaluation board (EZ-0008), the following software is required in addition to the above.
•Windows device driver for the EZ board
•DALI master controller GUI
•DMX512 master controller GUI
Please download the software from the respective download pages for the EZ-0011 and EZ-0008 at the following URL.
URL: http://www2.renesas.com/micro/ja/solution/lighting/download.html
3.1.2 Installing programming GUI for MINICUBE2
To write programs to the 78K0/IB2 on this product, the programming GUI for MINICUBE2 (QB-Programmer) is required.
Install it to the PC in the following steps.
Caution To use the programming GUI, a separate parameter file is required. For the actual steps for write
operation, refer to the QB-Programmer User's Manual (U18527E)
<1> Download the QB-Programmer from the download page for the EZ-0011.
<2> Click the installer file qbp_vxxx_j.exe to execute it. ("xxx" indicates the version.)
<3> Follow the instructions of the installer. Read the license agreement, and continue the installation if it is OK.
When the QB-Programmer is installed by default setting, the driver for MINICUBE2 is also instaled.
3.1.3 Installing assembler, compiler, and integrated debugger
To perform program development and on-chip debugging for the 78K0/IB2 on this product, the assembler, compiler, and
integrated debugger are required. Install them to the PC in the following steps.
<1> Download the assembler (RA78K0), compiler (CC78K0), and integrated debugger (ID78K0-QB) from the
download page for the EZ-0011.
<2> Click the assembler installer file ra78k0_wxxx_j.exe to execute it. ("xxx" indicates the version.)
<3> Follow the instructions of the installer. Read the license agreement, and continue the installation if it is OK.
<4> When the assembler is installed, the integrated development environment (PM+) is also installed.
<5> Similarly, install the compiler (installer file name: cc78k0_wxxxj.exe) and integrated debugger (installer file
name: id78k0-qb_v320_j.exe).
<6> Decompress the device file (compressed file name: df780756_vxxx.zip), and install it with the device file
installer.
(For details, refer to the help of the device file installer.)