Emulation Pod User's Manual
Table Of Contents
- Preface
- Contents
- 1. Precautions for Safety
- 2. Preparation
- 3. Setting Up
- 4. Usage
- 5. Specifications
- 6. Troubleshooting
- 6.1 Flowchart to Remedy the Troubles
- 6.2 When the Emulator Debugger Does Not Start Up Properly
- 6.3 Operation Differs from That of PROM Version MCUs
- (1) Does Not Operate with Operating Frequencies (3.6 V to 5.5 V) Properly
- (2) Does Not Operate with Operating Frequencies (2.7 V to 3.6 V) Properly
- (3) Cannot Reset from Target System
- (4) Data Values of ROM Area at Power-on Are Different
- (5) HOLD* control
- (6) A-D Conversion Values are Different from Expected Values
- (7) Outputs of ALE, Address and Others are Different from Those of Actual MCUs
- 7. Maintenance and Guarantee
( 58 / 78 )
Figure 5.8 Memory expansion mode and microprocessor mode (with wait, multiplex bus)
VCC = 3 V
Memory expansion mode and microprocessor mode
(with wait, accessing external memory area and using multiplex bus)
Read timing
BCLK
ALE
ADi
DBi
Write timing
BCLK
ALE
CSi
CSi
WR, WRL,
WRH
Conditions:
• V
CC =3 V
• Input timing voltage: VIL = 0.48 V, VIH = 1.5 V
• Output timing voltage: VOL = 1.5 V, VOH = 1.5 V
ADi
BHI
RD
ADi
DBi
ADi
BHI