Emulation Pod User's Manual
Table Of Contents
- Preface
- Contents
- 1. Precautions for Safety
- 2. Preparation
- 3. Setting Up
- 4. Usage
- 5. Specifications
- 6. Troubleshooting
- 6.1 Flowchart to Remedy the Troubles
- 6.2 When the Emulator Debugger Does Not Start Up Properly
- 6.3 Operation Differs from That of PROM Version MCUs
- (1) Does Not Operate with Operating Frequencies (3.6 V to 5.5 V) Properly
- (2) Does Not Operate with Operating Frequencies (2.7 V to 3.6 V) Properly
- (3) Cannot Reset from Target System
- (4) Data Values of ROM Area at Power-on Are Different
- (5) HOLD* control
- (6) A-D Conversion Values are Different from Expected Values
- (7) Outputs of ALE, Address and Others are Different from Those of Actual MCUs
- 7. Maintenance and Guarantee
( 54 / 78 )
Figure 5.6 Memory expansion mode and microprocessor mode (no-wait)
VCC = 3 V
Memory expansion mode and microprocessor mode (no-wait)
Read timing
BCLK
ALE
DB
RD
ADi
BHE
Write timing
BCLK
ALE
DB
ADi
BHE
CSi
CSi
WR, WRL,
WRH
Conditions:
• V
CC =3 V
• Input timing voltage: VIL = 0.48 V, VIH = 1.5 V
• Output timing voltage: VOL = 1.5 V, VOH = 1.5 V