Emulation Pod User's Manual
Table Of Contents
- Preface
- Contents
- 1. Precautions for Safety
- 2. Preparation
- 3. Setting Up
- 4. Usage
- 5. Specifications
- 6. Troubleshooting
- 6.1 Flowchart to Remedy the Troubles
- 6.2 When the Emulator Debugger Does Not Start Up Properly
- 6.3 Operation Differs from That of PROM Version MCUs
- (1) Does Not Operate with Operating Frequencies (3.6 V to 5.5 V) Properly
- (2) Does Not Operate with Operating Frequencies (2.7 V to 3.6 V) Properly
- (3) Cannot Reset from Target System
- (4) Data Values of ROM Area at Power-on Are Different
- (5) HOLD* control
- (6) A-D Conversion Values are Different from Expected Values
- (7) Outputs of ALE, Address and Others are Different from Those of Actual MCUs
- 7. Maintenance and Guarantee
( 37 / 78 )
Chapter 4. Usage
This chapter describes from turning on the power of this product to starting up the emulator debugger.
4.1 Turning On the Power ................................................................................................................ 38
(1) Checking the Connection of the Emulator System ............................................................... 38
(2) Turning On the Power........................................................................................................... 38
(3) LED Display When PC4701 Starts Up Normally ................................................................39
4.2 Downloading Firmware.............................................................................................................. 40
(1) When It is Necessary to Download Firmware ...................................................................... 40
(2) Downloading Firmware in Maintenance Mode .................................................................... 40
4.3 Self-check ................................................................................................................................... 41
(1) Self-check Procedure ............................................................................................................ 41
(2) If an Error is Detected in the Self-check............................................................................... 41