Emulation Pod User's Manual
Table Of Contents
- Preface
- Contents
- 1. Precautions for Safety
- 2. Preparation
- 3. Setting Up
- 4. Usage
- 5. Specifications
- 6. Troubleshooting
- 6.1 Flowchart to Remedy the Troubles
- 6.2 When the Emulator Debugger Does Not Start Up Properly
- 6.3 Operation Differs from That of PROM Version MCUs
- (1) Does Not Operate with Operating Frequencies (3.6 V to 5.5 V) Properly
- (2) Does Not Operate with Operating Frequencies (2.7 V to 3.6 V) Properly
- (3) Cannot Reset from Target System
- (4) Data Values of ROM Area at Power-on Are Different
- (5) HOLD* control
- (6) A-D Conversion Values are Different from Expected Values
- (7) Outputs of ALE, Address and Others are Different from Those of Actual MCUs
- 7. Maintenance and Guarantee
( 23 / 78 )
Chapter 3. Setting Up
This chapter describes switch settings required for using this product and how to connect this product to the PC4701 and
the target system.
3.1 Removing the Upper Cover........................................................................................................ 24
3.2 Setting Switches and Pullup Resistor .........................................................................................25
3.3 Selecting Clock Supply .............................................................................................................. 29
(1) Using the Oscillator Circuit on Target System ..................................................................... 30
(2) Changing the Internal Oscillator Circuit of Emulation Pod .................................................31
(3) Replacing the Oscillator Circuit Boards ............................................................................... 32
3.4 Connecting the PC4701 and Emulation Pod .............................................................................. 33
(1) Connecting the Cable to the PC4701 .................................................................................... 33
(2) Connecting the Cable to the Emulation Pod ......................................................................... 34
3.5 Connecting the Target System.................................................................................................... 35