Technical information

( 44 / 76 )
(4) Connecting to a 100-pin 0.65-mm-pitch Foot Pattern (Part 3)
Figure 3.17 shows how to connect the emulation pod probe to a 100-pin 0.65-mm-pitch QFP
(100P6S-A) foot pattern on the target system with the M3T-FLX-100NRB (not included), and here
following is its procedure. For details on the M3T-FLX-100NRB, refer to its user's manual.
(1) Attach the M3T-FLX-100NRB to the target system.
(2) Attach the M3T-FLX-100LCC to the M3T-FLX-100NRB.
Figure 3.17 Connecting a 100-pin 0.65-mm-pitch foot pattern (part 3)
CAUTION
Notes on Connecting the Target System:
• Take care not to attach the converter board in a wrong direction. It may cause a fatal
damage to the emulation pod.
• The small connectors of the M3T-FLX-100NRB are guaranteed for only 20
insertion/removal iterations.
FLX100
100-pin 0.65-mm-pitch
(100P6S-A) foot pattern
*
No. 1 pin
Target system*: These four products are available in one package.
NQPACK100RB
YQPACK100RB
YQSOCKET100RBF
MCU with
flash memory etc.
HQPACK100RB168
(separately available)
Evaluation with actual MCU
M3T-FLX-100NRB
(separately available)
(1)
(2)