Technical information

( 22 / 76 )
Please keep the M306NAT2-RPD-E's packing box and cushion material in your place for reuse at a
later time when sending your product for repair or other purposes. Always use these packing box and
cushion material when transporting this product.
If any of these items are missing or found faulty, please contact your local distributor. Also, if there
is any question or doubt about the packaged product, contact your local distributor.
For details on the IC61-1004-051, contact Yamaichi Electronics Co., Ltd.
2.2 Other Tool Products Required for Development
To bring forward programs development on the M16C/6N Group MCUs, the products listed below
are necessary in addition to those contained package above. Get them separately.
Table 2.2 Other tool products
* To purchase these products, contact your local distributor.
Chapter 2. Preparation
2.1 Package Components
The M306NAT2-RPD-E package consists of the following items. When unpacking, check to see if
your M306NAT2-RPD-E contains all of these items.
Table 2.1 Package components
Item
M306NAT2-RPD-E emulation pod main unit
FLX120-RPD flexible cable for connecting PC4701
M3T-FLX-100LCC converter board for connecting target system
OSC-3 16 MHz oscillator circuit board for main clock (premounted)
OSC-2 oscillator circuit board
IC61-1004-051 100-pin LCC socket
Resistor arrays for pulling up ports P00--P57 (51 kΩ)
Hardware tool user registration FAX sheet (English)
Hardware tool user registration FAX sheet (Japanese)
M306NAT2-RPD-E user's manual (this manual)
M306NAT2-RPD-E user's manual (Japanese)
Quantity
1
1
1
1
1
1
12
1
1
1
1
Product
Emulator main unit
Emulator debugger
Product name
PC4701
M3T-PD30
M3T-DUMMY100S
M3T-DIRECT100S
M3T-FLX-100NRB
100-pin 0.65-mm-pitch QFP
(100P6S-A)
Converter boards
Notes
Required
Required
Required according to the foot
pattern of the target system
(see 3.6 "Connecting the Target
System" on page 40)