Datasheet

Rev.6.00 Oct.28.2004 page 584 of 1016
REJ09B0138-0600H
19.7.2 Flash Memory Control Register 2 (FLMCR2)
Bit 76543210
FLER — — — — — ESU PSU
Initial value 0 0 0 0 0 0 0 0
Read/Write R — — — — — R/W R/W
FLMCR2 is an 8-bit register that monitors the presence or absence of flash memory program/erase protection (error
protection) and performs setup for flash memory program/erase mode. FLMCR2 is initialized to H'00 by a reset, and in
hardware standby mode. The ESU and PSU bits are cleared to 0 in software standby mode, hardware protect mode, and
software protect mode.
When on-chip flash memory is disabled, a read will return H'00.
Bit 7—Flash Memory Error (FLER): Indicates that an error has occurred during an operation on flash memory
(programming or erasing). When FLER is set to 1, flash memory goes to the error-protection state.
Bit 7
FLER Description
0 Flash memory is operating normally
Flash memory program/erase protection (error protection) is disabled
[Clearing condition]
Reset or hardware standby mode
(Initial value)
1 An error has occurred during flash memory programming/erasing
Flash memory program/erase protection (error protection) is enabled
[Setting condition]
See section 19.10.3, Error Protection
Bits 6 to 2—Reserved: These bits cannot be modified and are always read as 0.
Bit 1—Erase Setup (ESU): Prepares for a transition to erase mode. Set this bit to 1 before setting the E bit to 1 in
FLMCR1. Do not set the SWE, PSU, EV, PV, E, or P bit at the same time.
Bit 1
ESU Description
0 Erase setup cleared (Initial value)
1 Erase setup
[Setting condition]
When FWE = 1, and SWE = 1
Bit 0—Program Setup (PSU): Prepares for a transition to program mode. Set this bit to 1 before setting the P bit to 1 in
FLMCR1. Do not set the SWE, ESU, EV, PV, E, or P bit at the same time.