Datasheet

Rev.6.00 Oct.28.2004 page 569 of 1016
REJ09B0138-0600H
19.5 Programming (H8S/2357 ZTAT)
19.5.1 Overview
Table 19-6 shows how to select the program, verify, and program-inhibit modes in PROM mode.
Table 19-6 Mode Selection in PROM Mode
Pins
Mode CE OE PGM V
PP
V
CC
EO
7
to EO
0
EA
16
to EA
0
Program L H L V
PP
V
CC
Data input Address input
Verify L L H V
PP
V
CC
Data output Address input
Program-inhibit LLLV
PP
V
CC
High impedance Address input
LHH
HL L
HHH
Legend:
L: Low voltage level
H: High voltage level
V
PP
:V
PP
voltage level
V
CC
:V
CC
voltage level
Programming and verification should be carried out using the same specifications as for the standard HN27C101 EPROM.
However, do not set the PROM programmer to page mode, as the H8S/2357 does not support page programming. A
PROM programmer that only supports page programming cannot be used. When choosing a PROM programmer, check
that it supports high-speed programming in byte units. Always set addresses within the range H'00000 to H'1FFFF.