Datasheet

Rev.6.00 Oct.28.2004 page 302 of 1016
REJ09B0138-0600H
9.8.2 Register Configuration
Table 9-13 shows the port A register configuration.
Table 9-13 Port A Registers
Name Abbreviation R/W Initial Value Address*
1
Port A data direction register PADDR W H'00 H'FEB9
Port A data register PADR R/W H'00 H'FF69
Port A register PORTA R Undefined H'FF59
Port A MOS pull-up control register*
2
PAPCR R/W H'00 H'FF70
Port A open-drain control register*
2
PAODR R/W H'00 H'FF77
Notes: 1. Lower 16 bits of the address.
2. PAPCR and PAODR settings are prohibited in the ROMless version.
Port A Data Direction Register (PADDR)
Bit:76543210
PA7DDR PA6DDR PA5DDR PA4DDR PA3DDR PA2DDR PA1DDR PA0DDR
Initial value : 0 0 0 0 0 0 0 0
R/W:WWWWWWWW
PADDR is an 8-bit write-only register, the individual bits of which specify input or output for the pins of port A. PADDR
cannot be read; if it is, an undefined value will be read.
PADDR is initialized to H'00 by a power-on reset and in hardware standby mode. It retains its prior state after a manual
reset*, and in software standby mode. The OPE bit in SBYCR is used to select whether the address output pins retain their
output state or become high-impedance when a transition is made to software standby mode.
Note: * Manual reset is only supported in the H8S/2357 ZTAT.
• Mode 7
Setting a PADDR bit to 1 makes the corresponding port A pin an output port, while clearing the bit to 0 makes the pin
an input port.
• Mode 6
Setting a PADDR bit to 1 makes the corresponding port A pin an address output while clearing the bit to 0 makes the
pin an input port.
• Modes 4 and 5
The corresponding port A pins are address outputs irrespective of the value of bits PA4DDR to PA0DDR.
Setting one of bits PA7DDR to PA5DDR to 1 makes the corresponding port A pin an address output, while clearing
the bit to 0 makes the pin an input port.