Datasheet

Rev.6.00 Oct.28.2004 page 248 of 1016
REJ09B0138-0600H
Bit 7—DTC Software Activation Enable (SWDTE): Enables or disables DTC activation by software.
When clearing the SWDTE bit to 0 by software, write 0 to SWDTE after reading SWDTE set to 1.
Bit 7
SWDTE Description
0 DTC software activation is disabled (Initial value)
[Clearing condition]
When the DISEL bit is 0 and the specified number of transfers have not ended
1 DTC software activation is enabled
[Holding conditions]
• When the DISEL bit is 1 and data transfer has ended
• When the specified number of transfers have ended
• During data transfer due to software activation
Bits 6 to 0—DTC Software Activation Vectors 6 to 0 (DTVEC6 to DTVEC0): These bits specify a vector number for
DTC software activation.
The vector address is expressed as H'0400 + ((vector number) << 1). <<1 indicates a one-bit left-shift. For example,
when DTVEC6 to DTVEC0 = H'10, the vector address is H'0420.
8.2.9 Module Stop Control Register (MSTPCR)
MSTPCRH MSTPCRL
Bit :1514131211109876543210
Initial value : 0 0 1 1111111111111
R/W : R/W R/W R/W R/W R/W R/W R/W R/W R/W R/W R/W R/W R/W R/W R/W R/W
MSTPCR is a 16-bit readable/writable register that performs module stop mode control.
When the MSTP14 bit in MSTPCR is set to 1, the DTC operation stops at the end of the bus cycle and a transition is made
to module stop mode. However, 1 cannot be written in the MSTP14 bit while the DTC is operating. For details, see section
21.5, Module Stop Mode.
MSTPCR is initialized to H'3FFF by a reset and in hardware standby mode. It is not initialized in software standby mode.
Bit 14—Module Stop (MSTP14): Specifies the DTC module stop mode.
Bit 14
MSTP14 Description
0 DTC module stop mode cleared (Initial value)
1 DTC module stop mode set