Datasheet

Rev.6.00 Oct.28.2004 page 225 of 1016
REJ09B0138-0600H
Figure 7-26 shows an example of DREQ level activated block transfer mode transfer.
[1]
[2] [5]
[3] [6]
[4] [7]
Note: In write data buffer mode, bus breaks from [2] to [7] may be hidden, and not visible.
Acceptance after transfer enabling; the DREQ pin low level is sampled on the rising
edge of ø, and the request is held.
The request is cleared at the next bus break, and activation is started in the DMAC.
The DMA cycle is started.
Acceptance is resumed after the dead cycle is completed.
(As in [1], the DREQ pin low level is sampled on the rising edge of ø, and the request is held.)
DMA
read
DMA
right
ø
Address bus
DREQ
Idle Write
Bus release
DMA control
Channel
Write
Transfer
source
Request
[1] [3][2] [4] [6][5] [7]
Acceptance resumes
DMA
dead
Bus
release
DMA
read
DMA
right
DMA
dead
Bus
release
1 block transfer
IdleDead Dead
1 block transfer
Acceptance resumes
Request
Minimum of 2 cycles
Transfer
destination
Transfer
source
Transfer
destination
Minimum of 2 cycles
Read
Request clear period
Read
Request clear period
Idle
Figure 7-26 Example of DREQ Level Activated Block Transfer Mode Transfer
DREQ pin sampling is performed every cycle, with the rising edge of the next ø cycle after the end of the DMABCR write
cycle for setting the transfer enabled state as the starting point.
When the DREQ pin low level is sampled while acceptance by means of the DREQ pin is possible, the request is held in
the DMAC. Then, when activation is initiated in the DMAC, the request is cleared. After the end of the dead cycle,
acceptance resumes, DREQ pin low level sampling is performed again, and this operation is repeated until the transfer
ends.