Datasheet

Section 23 Power-Down Modes
Rev.6.00 Mar. 18, 2009 Page 836 of 980
REJ09B0050-0600
23.2.6 All-Module-Clocks-Stop Mode
When the ACSE bit in MSTPCRH is set to 1 and module stop mode is set for all the on-chip
peripheral functions controlled by MSTPCR or EXMSTPCR (MSTPCR = H'FFFF, EXMSTPCR
= H'FFFF), or for all the on-chip peripheral functions except the 8-bit timer (MSTPCR = H'FFFE,
EXMSTPCR = H'FFFF), executing a SLEEP instruction while the SSBY bit in SBYCR is cleared
to 0 will cause all the on-chip peripheral functions (except the 8-bit timer and watchdog timer), the
bus controller, and the I/O ports to stop operating, and a transition to be made to all-module-
clocks-stop mode, at the end of the bus cycle.
Operation or halting of the 8-bit timer can be selected by means of the MSTP0 bit.
All-module-clocks-stop mode is cleared by an external interrupt (NMI, IRQ0 to IRQ7 pins), RES
pin input, or an internal interrupt (8-bit timer, watchdog timer), and the CPU returns to the normal
program execution state via the exception handling state. All-module-clocks-stop mode is not
cleared if interrupts are disabled, if interrupts other than NMI are masked by the CPU, or if the
relevant interrupt is designated as a DTC activation source.
When the STBY pin is driven low, a transition is made to hardware standby mode.
23.3 φ Clock Output Control
Output of the φ clock can be controlled by means of the PSTOP bit in SCKCR, and DDR for the
corresponding port. When the PSTOP bit is set to 1, the φ clock stops at the end of the bus cycle,
and φ output goes high. φ clock output is enabled when the PSTOP bit is cleared to 0. When DDR
for the corresponding port is cleared to 0, φ clock output is disabled and input port mode is set.
Table 23.3 shows the state of the φ pin in each processing state.
Table 23.3 φ Pin State in Each Processing State
Register Setting
DDR PSTOP
Normal
operating state Sleep mode
Software
standby mode
Hardware
standby mode
All-module-
clocks-stop
mode
0 X High impedance High
impedance
High impedance High impedance High
impedance
1 0 φ output φ output Fixed high High impedance φ output
1 1 Fixed high Fixed high Fixed high High impedance Fixed high