Datasheet

Section 20 Flash Memory (0.18-μm F-ZTAT Version)
Rev.6.00 Mar. 18, 2009 Page 727 of 980
REJ09B0050-0600
• Flash program and erase frequency control (FPEFEQ)
• Flash vector address control register (FVACR)
There are several operating modes for accessing flash memory, for example, read mode/program
mode.
There are two memory MATs: user MAT and user boot MAT. The dedicated registers/parameters
are allocated for each operating mode and MAT selection. The correspondence of operating modes
and registers/parameters for use is shown in table 20.3.
Table 20.3 Register/Parameter and Target Mode
Download
Initiali-
zation
Program-
ming Erasure Read
FCCS ⎯ ⎯ ⎯ ⎯
FPCS ⎯ ⎯ ⎯ ⎯
FECS ⎯ ⎯ ⎯ ⎯
FKEY ⎯ ⎯
FMATS ⎯ ⎯
*
1
*
1
*
2
Programming/erasing
interface register
FTDAR
⎯ ⎯ ⎯ ⎯
Programming/erasing
interface parameter
DPFR ⎯ ⎯ ⎯ ⎯
FPFR ⎯ ⎯
FPEFEQ ⎯ ⎯ ⎯ ⎯
FUBRA ⎯ ⎯ ⎯ ⎯
FMPAR ⎯ ⎯ ⎯ ⎯
FMPDR ⎯ ⎯ ⎯ ⎯
FEBS ⎯ ⎯ ⎯ ⎯
Notes: 1. The setting is required when programming or erasing user MAT in user boot mode.
2. The setting may be required according to the combination of initiation mode and read
target MAT.