Datasheet

Section 14 Serial Communication Interface (SCI, IrDA)
Rev.6.00 Mar. 18, 2009 Page 559 of 980
REJ09B0050-0600
Smart Card Interface Mode (When SMIF in SCMR is 1)
Bit Bit Name Initial Value R/W Description
7 TDRE 1 R/(W)
*
1
Transmit Data Register Empty
Indicates whether TDR contains transmit data.
[Setting conditions]
• When the TE bit in SCR is 0
• When data is transferred from TDR to TSR,
and data writing to TDR is enabled.
[Clearing conditions]
• When 0 is written to TDRE after reading
TDRE = 1
• When the DMAC or DTC is activated by a TXI
interrupt request and transfers data to TDR
6 RDRF 0 R/(W)
*
1
Receive Data Register Full
Indicates that the received data is stored in RDR.
[Setting condition]
When serial reception ends normally and receive
data is transferred from RSR to RDR
[Clearing conditions]
• When 0 is written to RDRF after reading
RDRF = 1
• When the DMAC or DTC is activated by an
RXI interrupt and transferred data from RDR
The RDRF flag is not affected and retains its
previous value when the RE bit in SCR is cleared
to 0. Exercise care because if reception of the
next data is completed while the RDRF flag is set
to 1, an overrun error occurs and receive data
will be lost.