Datasheet

Rev.6.00 Mar. 18, 2009 Page lv of lviii

REJ09B0050-0600

Table 16.2 Analog Input Channels and Corresponding ADDR Registers................................ 665

Table 16.3 A/D Conversion Time (Single Mode) .................................................................... 672

Table 16.4 A/D Conversion Time (Scan Mode)....................................................................... 672

Table 16.5 A/D Converter Interrupt Source ............................................................................. 673

Table 16.6 Analog Pin Specifications ...................................................................................... 679

Section 17 D/A Converter

Table 17.1

Pin Configuration ................................................................................................... 683

Table 17.2 Control of D/A Conversion .................................................................................... 685

Section 19 Flash Memory (0.35-μm F-ZTAT Version)

Table 19.1

Differences between Boot Mode and User Program Mode.................................... 692

Table 19.2 Pin Configuration ................................................................................................... 697

Table 19.3 Erase Blocks........................................................................................................... 701

Table 19.4 Setting On-Board Programming Mode................................................................... 702

Table 19.5 Boot Mode Operation............................................................................................. 704

Table 19.6 System Clock Frequencies for which Automatic Adjustment of LSI Bit Rate

is Possible............................................................................................................... 705

Table 19.7 Flash Memory Operating States ............................................................................. 711

Section 20 Flash Memory (0.18-μm F-ZTAT Version)

Table 20.1 Comparison of Programming Modes ..................................................................... 721

Table 20.2 Pin Configuration ................................................................................................... 726

Table 20.3 Register/Parameter and Target Mode..................................................................... 727

Table 20.4 Parameters and Target Modes ................................................................................ 736

Table 20.5 Setting On-Board Programming Mode................................................................... 748

Table 20.6 System Clock Frequency for Automatic-Bit-Rate Adjustment by This LSI .......... 750

Table 20.7 Executable MAT .................................................................................................... 769

Table 20.8 (1) Useable Area for Programming in User Program Mode ...................................... 770

Table 20.8 (2) Useable Area for Erasure in User Program Mode................................................ 772

Table 20.8 (3) Useable Area for Programming in User Boot Mode ............................................ 774

Table 20.8 (4) Useable Area for Erasure in User Boot Mode...................................................... 776

Table 20.9 Hardware Protection............................................................................................... 778

Table 20.10 Software Protection ................................................................................................ 779

Table 20.11 Inquiry and Selection Commands .......................................................................... 786

Table 20.12 Programming/Erasing Command ........................................................................... 799

Table 20.13 Status Code............................................................................................................. 808

Table 20.14 Error Code.............................................................................................................. 809

Table 20.15 User Branch Processing Start Intervals .................................................................. 810