Datasheet

Section 8 Data Transfer Controller (DTC)
Rev.6.00 Mar. 18, 2009 Page 295 of 980
REJ09B0050-0600
8.2 Register Descriptions
DTC has the following registers.
• DTC mode register A (MRA)
• DTC mode register B (MRB)
• DTC source address register (SAR)
• DTC destination address register (DAR)
• DTC transfer count register A (CRA)
• DTC transfer count register B (CRB)
These six registers cannot be directly accessed from the CPU. When activated, the DTC reads a
set of register information that is stored in an on-chip RAM to the corresponding DTC registers
and transfers data. After the data transfer, it writes a set of updated register information back to the
RAM.
• DTC enable registers A to G (DTCERA to DTCERG)
• DTC vector register (DTVECR)
8.2.1 DTC Mode Register A (MRA)
MRA selects the DTC operating mode.
Bit Bit Name Initial Value R/W Description
7
6
SM1
SM0
Undefined
Undefined
−
−
Source Address Mode 1 and 0
These bits specify an SAR operation after a data
transfer.
0×: SAR is fixed
10: SAR is incremented after a transfer
(by +1 when Sz = 0; by +2 when Sz = 1)
11: SAR is decremented after a transfer
(by –1 when Sz = 0; by –2 when Sz = 1)
5
4
DM1
DM0
Undefined
Undefined
−
−
Destination Address Mode 1 and 0
These bits specify a DAR operation after a data
transfer.
0×: DAR is fixed
10: DAR is incremented after a transfer
(by +1 when Sz = 0; by +2 when Sz = 1)
11: DAR is decremented after a transfer
(by –1 when Sz = 0; by –2 when Sz = 1)