Datasheet

Section 27 Electrical Characteristics
Rev. 6.00 Mar. 18, 2010 Page 889 of 982
REJ09B0054-0600
Item Symbol Min Typ Max Unit Test Conditions
V
OL
⎯ ⎯ 0.4 V I
OL
= 0.4 mA Output low
voltage
All output
pins
*
3
⎯ ⎯ 0.4 V I
OL
= 0.8 mA
RES | I
in
| ⎯ ⎯ 1.0 µA Input leakage
current
STBY, NMI,
MD2 to MD0,
FWE
⎯ ⎯ 1.0 µA
Vin =
0.5 to V
CC
– 0.5 V
Ports 4, 9 ⎯ ⎯ 1.0 µA V
in
=
0.5 to AV
CC
– 0.5 V
Three-state
leakage
current
(off state)
Ports 1, 3, 7,
A to G
| I
TSI
| ⎯ ⎯ 1.0 µA V
in
=
0.5 to V
CC
– 0.5 V
Input pull-up
MOS current
Ports A to E –I
P
10 ⎯ 300 µA V
in
= 0 V
Notes: 1. If the A/D and D/A converters are not used, do not leave the AV
CC
, V
ref
, and AV
SS
pins
open. Apply a voltage between 2.0 V and 5.5 V to the AV
CC
and V
ref
pins by connecting
them to V
CC
, for instance. Set V
ref
≤ AV
CC
.
2. P35/SCK1/SCL0 and P34/SDA0 are NMOS push-pull outputs.
In order to output a high level from SCL0 and SDA0 (ICE = 1), a pull-up resistance must
be connected externally.
The high level of P35/SCK1 and P34 (ICE = 0) is driven by NMOS.
In order to output a high level, a pull-up resistance must be connected externally.
3. This is the case when IICE = 0 and ICE = 0. Low-level output when the bus drive
function is selected will be determined in table 27.29.