Datasheet

Section 8 DMA Controller (DMAC)
Rev. 6.00 Mar. 18, 2010 Page 225 of 982
REJ09B0054-0600
Bit Bit Name Initial Value R/W Description
6 DTE1 0 R/W Data Transfer Enable 1
Enables or disables DMA transfer for the
activation source selected by the DTF3 to DTF0
bits in DMACR of channel 1.
When DTE1 = 0, data transfer is disabled and
the activation source is ignored. If the activation
source is an internal interrupt, an interrupt
request is issued to the CPU or DTC. If the
DTE1 bit is cleared to 0 when DTIE1 = 1, the
DMAC regards this as indicating the end of a
transfer, and issues a transfer end interrupt
request to the CPU.
When DTE1 = 1 and DTME1 = 1, data transfer
is enabled and the DMAC waits for a request by
the activation source. When a request is issued
by the activation source, DMA transfer is
executed.
0: Data transfer is disabled
1: Data transfer is enabled
[Clearing conditions]
• When initialization is performed
• When the specified number of transfers
have been completed
• When 0 is written to the DTE1 bit to forcibly
suspend the transfer, or for a similar reason
[Setting condition]
When 1 is written to the DTE1 bit after reading
DTE1 = 0