Datasheet

Section 16 A/D Converter
Page 604 of 846 REJ09B0140-0900 Rev. 9.00
Sep 16, 2010
H8S/2215 Group
16.3.1 A/D Data Registers A to D (ADDRA to ADDRD)
There are four 16-bit read-only ADDR registers; ADDRA to ADDRD, used to store the results of
A/D conversion. The ADDR registers, which store a conversion result for each channel, are shown
in table 16.2.
The converted 10-bit data is stored in bits 6 to 15. The lower 6 bits are always read as 0.
The data bus between the CPU and the A/D converter is 8 bits wide. The upper byte can be read
directly from the CPU, however the lower byte should be read via a temporary register. The
temporary register contents are transferred from the ADDR when the upper byte data is read.
When reading the ADDR, read the upper byte before the lower byte, or read in word unit.
The initial value of ADDR is H'0000.
Table 16.2 Analog Input Channels and Corresponding ADDR Registers
Analog Input Channel A/D Data Register to Be Stored the Results of A/D Conversion
AN0 ADDRA
AN1 ADDRB
AN2, AN14 ADDRC
AN3, AN15 ADDRD
16.3.2 A/D Control/Status Register (ADCSR)
ADCSR controls A/D conversion operations.
Bit Bit Name Initial Value R/W Description
7 ADF 0
R/(W)
*
A/D End Flag
A status flag that indicates the end of A/D conversion.
[Setting conditions]
• When A/D conversion ends
• When A/D conversion ends on all channels specified
in scan mode
[Clearing conditions]
• When 0 is written after reading ADF = 1
• When the DMAC or DTC is activated by an ADI
interrupt and ADDR is read when DISEL = 0 and the
transfer counter ≠ 0