Datasheet

Section 7 DMA Controller (DMAC)
Rev.7.00 Dec. 24, 2008 Page 185 of 698
REJ09B0074-0700
Transfer requests (activation sources) consist of A/D conversion end interrupt, SCI transmission
complete and reception complete interrupts, and TPU channel 0 to 2 compare match/input capture
A interrupts. Figure 7.7 shows an example of the setting procedure for repeat mode.
Repeat mode
setting
Read DMABCRH
Set transfer source
and transfer destination
addresses
Set number of transfers
Set DMACR
Read DMABCRL
Set DMABCRL
Repeat mode
[1]
[2]
[3]
[4]
[5]
[6]
[1] Set each bit in DMABCRH.
· Clear the FAE bit to 0 to select short address
mode.
· Specify enabling or disabling of internal interrupt
clearing with the DTA bit.
[2] Set the transfer source address and transfer
destination address in MAR and IOAR.
[3] Set the number of transfers in ETCR.
[4] Set each bit in DMACR.
· Set the transfer data size with the DTSZ bit.
· Specify whether MAR is to be incremented or
decremented with the DTID bit.
· Set the RPE bit to 1.
· Specify the transfer direction with the DTDIR bit.
· Select the activation source with bits DTF3 to
DTF0.
[5] Read the DTE bit in DMABCRL as 0.
[6] Set each bit in DMABCRL.
· Clear the DTIE bit to 1.
· Set the DTE bit to 1 to enable transfer.
Figure 7.7 Example of Repeat Mode Setting Procedure