Datasheet

Rev. 3.00, 03/04, page 734 of 830
23.1.4 Sub-Chip Module Stop Control Registers BH, BL (SUBMSTPBH, SUBMSTPBL)
SUBMSTPB specifies on-chip peripheral modules to shift to module stop mode in module units.
Each module can enter module stop mode by setting the corresponding bit to 1.
• SUBMSTPBH
Bit Bit Name
Initial
Value R/W Corresponding Module
7 to 0 SMSTPB15
to SMSTPB8
All 1 R/W Reserved
The initial values should not be changed.
• SUBMSTPBL
Bit Bit Name
Initial
Value R/W Corresponding Module
7 to 1 SMSTPB7
to SMSTPB1
All 1 R/W Reserved
The initial values should not be changed.
0 SMSTPB0 1 R/W LPC interface (LPC)
23.1.5 Sub-Chip Module Stop Control Registers AH, AL (SUBMSTPAH, SUBMSTPAL)
Set the values in SUBMSTPAH and SUBMSTPAL same as in SUBMSTPBH and SUBMSTPBL.
• SUBMSTPAH
Bit Bit Name
Initial
Value R/W Corresponding Module
7 to 0 SMSTPA15
to SMSTPA8
All 1 W Reserved
The initial values should not be changed.
• SUBMSTPAL
Bit Bit Name
Initial
Value R/W Corresponding Module
7 to 1 SMSTPA7
to SMSTPA1
All 1 W Reserved
The initial values should not be changed.
0 SMSTPA0 1 W LPC interface (LPC)