Datasheet

Rev. 3.00, 03/04, page 503 of 830
Note: This restriction on usage can be canceled by setting the FNC1 and FNC0 bits to B'11 in
ICXR.
11. Note on ICDR register read and ICCR register access in slave transmit mode
In I
2
C bus interface slave transmit mode, do not read ICDR or do not read/write from/to ICCR
during the time shaded in figure 15.33. However, such read and write operations source no
problem in interrupt handling processing that is generated in synchronization with the rising
edge of the 9th clock pulse because the shaded time has passed before making the transition to
interrupt handling.
To handle interrupts securely, be sure to keep either of the following conditions.
 Read ICDR data that has been received so far or read/write from/to ICCR before starting
the receive operation of the next slave address.
 Monitor the BC2 to BC0 counter in ICMR; when the count is B'000 (8th or 9th clock
pulse), wait for at least two transfer clock times in order to read ICDR or read/write from/to
ICCR during the time other than the shaded time.
Data transmission
Bit 7
Address reception
SCL
TRS bit
Waveform at problem occurrence
ICDR read and ICCR read/write are disabled
(6 system clock period)
8
R/W
A
9
The rise of the 9th clock is detected
SDA
ICDR write
Figure 15.33 ICDR Register Read and ICCR Register Access Timing in Slave Transmit
Mode
Note: This restriction on usage can be canceled by setting the FNC1 and FNC0 bits to B'11 in
ICXR.