Datasheet

Section 27 Electrical Characteristics
Rev. 3.00 Mar 21, 2006 page 704 of 788
REJ09B0300-0300
Item Symbol Min Typ Max Unit
Test
Conditions
All output pins
(except RESO)
*
5
(Ports C to G are
added in the
H8S/2160B and
H8S/2161B.)
——0.4VI
OL
= 1.6 mA
Ports 1 to 3 — — 1.0 V I
OL
= 5 mA
Output low
voltage
RESO
V
OL
——0.4VI
OL
= 1.6 mA
Notes: 1. Do not leave the AVcc, AVref, and AVss pins open even if the A/D converter and D/A
converter are not used.
Even if the A/D converter and D/A converter are not used, apply a value in the range 2.0
V to 3.6 V to AV
CC
and AV
ref
pins by connection to the power supply (V
CC
), or some other
method. Ensure that AV
ref
≤ AV
CC
.
2. P67 to P60 include peripheral module inputs multiplexed on those pins.
3. IRQ2 includes the ADTRG signal multiplexed on that pin.
4. P52/SCK0/SCL0, P97/SDA0, P86/SCK1/SCL1, P42/SCK2/SDA1, and port G are
NMOS push-pull outputs.
When the SCL0, SDA0, SCL1, or SDA1 (ICE = 1) pin is used as an output, it is NMOS
open-drain output. Therefore, an external pull-up resistor must be connected in order to
output high level.
P52/SCK0, P97, P86/SCK1, P42/SCK2 (ICE = 0), and port G high levels are driven by
NMOS.
An external pull-up resistor is necessary to provide high-level output from SCK0, SCK1,
and SCK2.
5. When IICS = 0, ICE = 0, and KBIOE = 0. Low-level output when the bus drive function
is selected is determined separately.
6. The upper limit of the port 6 applied voltage is V
CC
+ 0.3 V when CIN input is not
selected, and the lower of V
CC
+ 0.3 V and AV
CC
+ 0.3 V when CIN input is selected.
When a pin is in output mode, the output voltage is equivalent to the applied voltage.
7. The upper limit of the port A applied voltage is V
CC
B + 0.3 V when CIN input is not
selected, and the lower of V
CC
B + 0.3 V and AV
CC
+ 0.3 V when CIN input is selected.
When a pin is in output mode, the output voltage is equivalent to the applied voltage.
8. The port A characteristics depend on V
CC
B, and the other pins characteristics depend
on V
CC
.
9. For flash memory programming/erasure, the applicable range is V
CC
= 3.0 V to 3.6 V.