Datasheet

Section 15 Serial Communication Interface (SCI and IrDA)
Rev. 3.00 Mar 21, 2006 page 411 of 788
REJ09B0300-0300
15.9.8 Notes on Switching from SCK Pins to Port Pins
When SCK pins are switched to port pins after transmission has completed, pins are enabled for
port output after outputting a low pulse of half a cycle as shown in figure 15.28.
SCK/Port
CKE0
CKE1
C/A
TE
Data
1. Transmission end
2. TE = 0
3. C/A = 0
4. Low pulse output
Bit 6 Bit 7
Low pulse of half a cycle
Figure 15.28 Switching from SCK Pins to Port Pins
To prevent the low pulse output that is generated when switching the SCK pins to the port pins,
specify the SCK pins for input (pull up the SCK/port pins externally), and follow the procedure
below with DDR = 1, DR = 1, C/A = 1, CKE1 = 0, CKE1 = 0, and TE = 1.
1. End serial data transmission
2. TE bit = 0
3. CKE1 bit = 1
4. C/A bit = 0 (switch to port output)
5. CKE1 bit = 0
SCK/Port
CKE0
CKE1
C/A
TE
Data
1. Transmission end
2. TE = 0
4. C/A = 0
3. CKE1 = 1
5. CKE1 = 0
Bit 6 Bit 7
High output
Figure 15.29 Prevention of Low Pulse Output at Switching from SCK Pins to Port Pins