Datasheet

Section 23 ROM (H8S/2148 F-ZTAT A-Mask Version, H8S/2147 F-ZTAT A-Mask Version, H8S/2144 F-ZTAT A-Mask Version)
Rev. 4.00 Sep 27, 2006 page 718 of 1130
REJ09B0327-0400
23.10.2 Socket Adapters and Memory Map
In programmer mode, a socket adapter is mounted on the writer programmer to match the package
concerned. Socket adapters are available for each writer manufacturer supporting Renesas
Technology microcomputer device types with 128-kbyte or 64-kbyte on-chip flash memory
(V
PP
= 3.3 V).
Figure 23.15 shows the memory map in programmer mode. For pin names in programmer mode,
see section 1.3.2, Pin Functions in Each Operating Mode.
H'000000
MCU mode Programmer mode
H'00000
H'1FFFF
H'0FFFF
H'00FFFF
On-chip
ROM area
Undefined
value output
H8S/2147 A-mask version
H'000000
MCU mode Programmer mode
H'00000
H'1FFFF
H'01FFFF
On-chip
ROM area
H8S/2148 A-mask version
H8S/2144 A-mask version
Figure 23.15 Memory Map in Programmer Mode
23.10.3 Programmer Mode Operation
Table 23.11 shows how the different operating modes are set when using programmer mode, and
table 23.12 lists the commands used in programmer mode. Details of each mode are given below.
• Memory Read Mode
Memory read mode supports byte reads.
• Auto-Program Mode
Auto-program mode supports programming of 128 bytes at a time. Status polling is used to
confirm the end of auto-programming.
• Auto-Erase Mode
Auto-erase mode supports automatic erasing of the entire flash memory. Status polling is used
to confirm the end of auto-erasing.
• Status Read Mode
Status polling is used for auto-programming and auto-erasing, and normal termination can be
confirmed by reading the FO6 signal. In status read mode, error information is output if an
error occurs.