Datasheet

Section 5 Interrupt Controller
Rev. 4.00 Sep 27, 2006 page 121 of 1130
REJ09B0327-0400
Bits 7 to 0—IRQ7 to IRQ0 Flags (IRQ7F to IRQ0F): These bits indicate the status of IRQ7 to
IRQ0 interrupt requests.
Bit n
IRQnF Description
0 [Clearing conditions] (Initial value)
• Cleared by reading IRQnF when set to 1, then writing 0 in IRQnF
• When interrupt exception handling is executed while low-level detection is set
(IRQnSCB = IRQnSCA = 0) and IRQn input is high
*
• When IRQn interrupt exception handling is executed while falling, rising, or both-edge
detection is set (IRQnSCB = 1 or IRQnSCA = 1)
*
1 [Setting conditions]
• When IRQn input goes low when low-level detection is set (IRQnSCB = IRQnSCA = 0)
• When a falling edge occurs in IRQn input while falling edge detection is set
(IRQnSCB = 0, IRQnSCA = 1)
• When a rising edge occurs in IRQn input while rising edge detection is set
(IRQnSCB = 1, IRQnSCA = 0)
• When a falling or rising edge occurs in IRQn input while both-edge detection is set
(IRQnSCB = IRQnSCA = 1)
Notes: n = 7 to 0
* When a product, in which a DTC is incorporated, is used in the following settings, the
corresponding flag bit is not automatically cleared even when exception handling, which
is a clear condition, is executed and the bit is held at 1.
(1) When DTCEA3 is set to 1 (ADI is set to an interrupt source), IRQ4F flag is not
automatically cleared.
(2) When DTCEA2 is set to 1 (ICIA is set to an interrupt source), IRQ5F flag is not
automatically cleared.
(3) When DTCEA1 is set to 1 (ICIB is set to an interrupt source), IRQ6F flag is not
automatically cleared.
(4) When DTCEA0 is set to 1 (OCIA is set to an interrupt source), IRQ7F flag is not
automatically cleared.
When activation interrupt sources of DTC and IRQ interrupts are used with the above
combinations, clear the interrupt flag by software in the interrupt handling routine of the
corresponding IRQ.