Datasheet

Section 25 Electrical Characteristics
Rev. 4.00 Jun 06, 2006 page 742 of 1004
REJ09B0301-0400
3. IRQ2 includes the ADTRG signal multiplexed on that pin.
4. P52/SCK0/SCL0 and P97/SDA0 are NMOS push-pull outputs in H8S/2138.
An external pull-up resistor is necessary to provide high-level output from SCL0 and
SDA0 (ICE = 1).
P52/SCK0 and P97 (ICE = 0) high levels are driven by NMOS in H8S/2138.
5. When ICE = 0. Low-level output when the bus drive function is selected is determined
separately.
6. The upper limit of the port 6 applied voltage is V
CC
+0.3 V when CIN input is not
selected, and the lower of V
CC
+0.3 V and AV
CC
+0.3 V when CIN input is selected.
When a pin is in output mode, the output voltage is equivalent to the applied voltage.
7. For flash memory program/erase operations, the applicable ranges are V
CC
= 3.0 V to
3.6 V.
8. Current dissipation values are for V
IH
min = V
CC
–0.2 V and V
IL
max = 0.2 V with all
output pins unloaded and the on-chip pull-up MOSs in the off state.
9. The values are for V
RAM
≤ V
CC
< 2.7 V, V
IH
min = V
CC
–0.2 V, and V
IL
max = 0.2 V.