Datasheet

Section 21 ROM (Mask ROM Version, H8S/2138 F-ZTAT, H8S/2134 F-ZTAT, and H8S/2132 F-ZTAT)
Rev. 4.00 Jun 06, 2006 page 610 of 1004
REJ09B0301-0400
21.10.2 Socket Adapters and Memory Map
In programmer mode, a socket adapter is mounted on the writer programmer to match the package
concerned. Socket adapters are available for each writer manufacturer supporting Renesas
Technology microcomputer device types with 128-kbyte or 64-kbyte on-chip flash memory.
Figure 21.15 shows the memory map in programmer mode. For pin names in programmer mode,
see section 1.3.2, Pin Functions in Each Operating Mode.
H8S/2138
H8S/2134
H'000000
MCU mode
Programmer
mode
H'01FFFF
H'00000
H'1FFFF
On-chip
ROM area
H'000000
MCU mode
Programmer
mode
H'00000
H'1FFFF
H'00FFFF H'0FFFF
On-chip
ROM area
Undefined value
output
H8S/2132
Figure 21.15 Memory Map in Programmer Mode
21.10.3 Programmer Mode Operation
Table 21.11 shows how the different operating modes are set when using programmer mode, and
table 21.12 lists the commands used in programmer mode. Details of each mode are given below.
• Memory Read Mode
Memory read mode supports byte reads.
• Auto-Program Mode
Auto-program mode supports programming of 128 bytes at a time. Status polling is used to
confirm the end of auto-programming.
• Auto-Erase Mode
Auto-erase mode supports automatic erasing of the entire flash memory. Status polling is used
to confirm the end of auto-erasing.
• Status Read Mode
Status polling is used for auto-programming and auto-erasing, and normal termination can be
confirmed by reading the FO6 signal. In status read mode, error information is output if an
error occurs.