Datasheet

Section 7 Data Transfer Controller [H8S/2138 Group]
Rev. 4.00 Jun 06, 2006 page 159 of 1004
REJ09B0301-0400
Section 7 Data Transfer Controller [H8S/2138 Group]
Provided in the H8S/2138 Group; not provided in the H8S/2134 Group.
7.1 Overview
The H8S/2138 Group includes a data transfer controller (DTC). The DTC can be activated by an
interrupt or software, to transfer data.
7.1.1 Features
• Transfer possible over any number of channels
 Transfer information is stored in memory
 One activation source can trigger a number of data transfers (chain transfer)
• Wide range of transfer modes
 Normal, repeat, and block transfer modes available
 Incrementing, decrementing, and fixing of transfer source and destination addresses can be
selected
• Direct specification of 16-Mbyte address space possible
 24-bit transfer source and destination addresses can be specified
• Transfer can be set in byte or word units
• A CPU interrupt can be requested for the interrupt that activated the DTC
 An interrupt request can be issued to the CPU after one data transfer ends
 An interrupt request can be issued to the CPU after all specified data transfers have ended
• Activation by software is possible
• Module stop mode can be set
 The initial setting enables DTC registers to be accessed. DTC operation is halted by setting
module stop mode