Datasheet

Section 22 Flash Memory
Rev. 3.00 Sep. 28, 2009 Page 716 of 910
REJ09B0350-0300
Yes
No
Start erasing
procedure program
Set FKEY to H'A5
Yes
No
Download error processing
Set the FPEFEQ
parameter
End erasing
procedure program
FPFR = 0?
Initialization error processing
Disable interrupts
and bus master operation
other than CPU
Clear FKEY to 0
Set parameters to
ER0 and ER1
(FMPAR and FMPDR)
Yes
No
Clear FKEY and erasing
error processing
*
Yes
Required
block erasing is
completed?
No
Set FKEY to H'A5
Clear FKEY to 0
1
1
Download
Initialization
Programming
Set FMATS to value other
than H'AA to select user MAT
Set SCO to 1 and
execute download
Set FMATS to H'AA to
select user boot MAT
User-boot-MAT selection state
User-MAT selection state
User-boot-MAT
selection state
MAT
switchover
MAT
switchover
DPFR = 0?
Initialization
JSR FTDAR setting + 32
Programming
JSR FTDAR setting + 16
FPFR = 0?
Select on-chip program
to be downloaded and
specify download
destination by FTDAR
Note: * The MAT must be switched by FMATS
to perform the erasing error processing
in the user boot MAT.
Figure 22.14 Procedure for Programming User MAT in User Boot Mode
The difference between the programming procedures in user program mode and user boot mode is
whether the MAT is switched or not as shown in figure 22.14.
In user boot mode, the user boot MAT can be seen in the flash memory space with the user MAT
hidden in the background. The user MAT and user boot MAT are switched only while the user
MAT is being programmed. Because the user boot MAT is hidden while the user MAT is being
programmed, the procedure program must be executed in an area other than flash memory. After
the programming procedure completes, switch the MATs again to return to the first state.