Datasheet

Section 16 Serial Communication Interface with FIFO (SCIF)
Rev. 3.00 Sep. 28, 2009 Page 478 of 910
REJ09B0350-0300
Bit Bit Name Initial Value R/W Description
2 STOP 0 R/W Stop Bit
Specifies the stop bit length for data transmission.
For data reception, only the first stop bit is checked
regardless of the setting.
0: 1 stop bit
1: 1.5 stop bits (data length: 5 bits) or 2 stop bits
(data length: 6 to 8 bits)
1
0
CLS1
CLS0
0
0
R/W
R/W
Character Length Select 1, 0
These bits specify transmit/receive character data
length.
00: Data length is 5 bits
01: Data length is 6 bits
10: Data length is 7 bits
11: Data length is 8 bits
16.3.10 Modem Control Register (FMCR)
FMCR controls output signals.
Bit Bit Name Initial Value R/W Description
7 to 5 ⎯ All 0 R Reserved
These bits are always read as 1 and cannot be
modified.
4 LOOP
BACK
0 R/W Loopback Test
The transmit data output is internally connected to
the receive data input, and the transmit data output
pin (FRxD) becomes 1. The receive data input pin is
disconnected from external sources. The four modem
control input pins (DSR, CTS, RI, and DCD) are
disconnected from external sources, and the pins are
internally connected to the four modem control output
signals (DTR, RTS, OUT1, and OUT2), respectively.
The transmit data is received immediately in
loopback mode. Enabling/disabling of interrupts is set
by the OUT2LOOP bit in SCIFCR and FIER.
0: Loopback function disabled
1: Loopback function enabled