Datasheet

Section 15 Serial Communication Interface (SCI)
Rev. 3.00 Sep. 28, 2009 Page 459 of 910
REJ09B0350-0300
15.8 Interrupt Sources
15.8.1 Interrupts in Normal Serial Communication Interface Mode
Table 15.13 shows the interrupt sources in normal serial communication interface mode. A
different interrupt vector is assigned to each interrupt source, and individual interrupt sources can
be enabled or disabled using the enable bits in SCR.
When the TDRE flag in SSR is set to 1, a TXI interrupt request is generated. When the TEND flag
in SSR is set to 1, a TEI interrupt request is generated.
When the RDRF flag in SSR is set to 1, an RXI interrupt request is generated. When the ORER,
PER, or FER flag in SSR is set to 1, an ERI interrupt request is generated.
A TEI interrupt is requested when the TEND flag is set to 1 while the TEIE bit is set to 1. If a TEI
interrupt and a TXI interrupt are requested simultaneously, the TXI interrupt has priority for
acceptance. However, note that if the TDRE and TEND flags are cleared simultaneously by the
TXI interrupt routine, the SCI cannot branch to the TEI interrupt routine later.
Table 15.13 SCI Interrupt Sources
Channel Name Interrupt Source Interrupt Flag Priority
ERI1 Receive error ORER, FER, PER
RXI1 Receive data full RDRF
TXI1 Transmit data empty TDRE
1
TEI1 Transmit end TEND
ERI2 Receive error ORER, FER, PER
RXI2 Receive data full RDRF
2
TXI2 Transmit data empty TDRE
High
TEI2 Transmit end TEND Low