Datasheet

Rev. 3.00 Sep. 28, 2009 Page xxiv of xliv
REJ09B0350-0300
Item Page Revision (See Manual for Details)
22.12 Standard Serial
Communication Interface
Specifications for Boot Mode
(8) Programming/Erasing State
(f) Memory Read
752 • Area (1 byte)
H'00: User boot MAT
H'01: User MAT
An address error occurs when the area
setting is incorrect.
22.13 Usage Notes 757 Description amended
5. Do not power off the Vcc power supply (including
the removal of the chip from the PROM
programmer) during programming/erasing in which
a high voltage is applied to the flash memory. Doing
so may damage the flash memory permanently. If a
reset is input, the reset must be released after the
reset input period of at least 100μs.
Description amended
7. At powering on the Vcc power supply, fix the RES
pin to low and set the flash memory to hardware
protection state. This power on timing must also be
satisfied at a power-off and power-on caused by a
power failure and other factors.
25.1 Register Addresses
(Address Order)
788 Table amended
Register Name Abbreviation Address Module
A/D data register A
A/D data register B
A/D data register C
A/D data register D
A/D data register E
A/D data register F
A/D data register G
A/D data register H
ADDRA
ADDRB
ADDRC
ADDRD
ADDRE
ADDRF
ADDRG
ADDRH
H'FC00
H'FC02
H'FC04
H'FC06
H'FC08
H'FC0A
H'FC0C
H'FC0E
16
16
16
16
16
16
16
16
A/D
converter
A/D
converter
A/D
converter
A/D
converter
A/D
converter
A/D
converter
A/D
converter
A/D
converter
16
16
16
16
16
16
16
16
2
2
2
2
2
2
2
2
Number
of bits
Data
Width
Access
States