Datasheet

Rev. 3.00 Sep. 28, 2009 Page xxii of xliv
REJ09B0350-0300
Item Page Revision (See Manual for Details)
22.8.4 Storable Areas for On-
Chip Program and Program Data
Table 22.10 Usable Area for
Programming in User Program
Mode
720 Table amended
Item On-Chip RAM User MAT
Storable/Executable Area Selected MAT
User MAT
Operation for initialization error
Operation for disabling interrupts
O
O
O
O
O
O
Embedded
Program
Storage MAT
Table 22.11 Usable Area for
Erasure in User Program Mode
721 Table amended
Item On-Chip RAM User MAT
Storable/Executable Area Selected MAT
User MAT
Operation for initialization error
Operation for disabling interrupts
O
O
O
O
O
O
Embedded
Program
Storage MAT
Table 22.12 Usable Area for
Programming in User Boot Mode
722 Table added
Table 22.13 Usable Area for
Erasure in User Boot Mode
723 Table added
22.11 Programmer Mode
Table 22.16 Device Types
Supported in Programmer Mode
728 Table amended
Target Memory MAT R/W Description
User MAT
User boot MAT
256 kbytes*
8 kbytes
FZTAT256V3A
FZTATUSBTV3A
Note amended
Note: * For the R4F2117 model, 160 kbytes of ROM
space is available when the user MAT is
selected. If programming is performed in
programmer mode, H'FF data must be written
to address H'28000 to H'3FFFF with 256-kbyte
capacity setting.
22.12 Standard Serial
Communication Interface
Specifications for Boot Mode
728 Description amended
2. Inquiry/selection state
In this state, the boot program responds to inquiry
commands from the host. The device name, clock
mode, and bit rate are selected. After selection of
these settings, the program is made to enter the
programming/erasing state by the command for a
transition to the programming/erasing state. The
program transfers the libraries required for erasure
to the on-chip RAM and erases the user MATs and
user boot MATs before the transition.