Datasheet

Section 9 Data Transfer Controller (DTC)
Rev. 3.00 Mar 17, 2006 page 401 of 926
REJ09B0283-0300
Section 9 Data Transfer Controller (DTC)
This LSI includes a data transfer controller (DTC). The DTC can be activated by an interrupt or
software, to transfer data.
Figure 9.1 shows a block diagram of the DTC. The DTC’s register information is stored in the on-
chip RAM. When the DTC is used, the RAME bit in SYSCR must be set to 1. A 32-bit bus
connects the DTC to the on-chip RAM (1 kbyte), enabling 32-bit/1-state reading and writing of
the DTC register information.
9.1 Features
• Transfer possible over any number of channels
• Three transfer modes
Normal, repeat, and block transfer modes available
• One activation source can trigger a number of data transfers (chain transfer)
• Direct specification of 16-Mbyte address space possible
• Activation by software is possible
• Transfer can be set in byte or word units
• A CPU interrupt can be requested for the interrupt that activated the DTC
• Module stop mode can be set
DTCH804A_010020020400