Datasheet

Section 8 EXDMA Controller
Rev. 3.00 Mar 17, 2006 page 341 of 926
REJ09B0283-0300
8.3.4 EXDMA Mode Control Register (EDMDR)
EDMDR controls EXDMAC operations.
Bit Bit Name Initial Value R/W Description
15 EDA 0 R/(W) EXDMA Active
Enables or disables data transfer on the
corresponding channel. When this bit is set to
1, this indicates that an EXDMA operation is in
progress.
When auto request mode is specified (by bits
MDS1 and MDS0), transfer processing begins
when this bit is set to 1. With external requests,
transfer processing begins when a transfer
request is issued after this bit has been set to 1.
When this bit is cleared to 0 during an EXDMA
operation, transfer is halted. If this bit is cleared
to 0 during an EXDMA operation in block
transfer mode, transfer processing is continued
for the currently executing one-block transfer,
and the bit is cleared on completion of the
currently executing one-block transfer.
If an external source that ends (aborts) transfer
occurs, this bit is automatically cleared to 0 and
transfer is terminated. Do not change the
operating mode, transfer method, or other
parameters while this bit is set to 1.
0: Data transfer disabled on corresponding
channel
[Clearing conditions]
• When the specified number of transfers end
• When operation is halted by a repeat area
overflow interrupt
• When 0 is written to EDA while EDA = 1
(In block transfer mode, write is effective
after end of one-block transfer)
• Reset, NMI interrupt, hardware standby
mode
1: Data transfer enabled on corresponding
channel
Note: The value written in the EDA bit may not
be effective immediately.